Simple Coin Jig ~40mm

This is a simple Coin jig. It requires a single standard screw to mount. 

I would highly recommend using a heat resistant plastic like PETG or ASA.

This is good for quick marking, it is unlikely it would hold up to any deep engraving.

Height of the top is 8mm to allow for any standard screws to fit and not cause issues with the coin fully seating. Uses standard 25mm Spacing.

There is 3 different files with slightly different tolerances. Hopefully one will work well for you.

This product is for personal use only, It may not be shared or resold. You will be provided a zip file with an .stl file located inside.

Note: You may need a well calibrated 3D printer like the bambu X1C. I left the tolerances tight to keep things aligned. If you can't get them to work contact me and I can adjust tolerances.